7
4
ADD UNITS TO AN EXISTING SITE GROUP
Repeat sections 2 and 3.
5
POSITION UNITS
Once activated and paired, WES3 units can be installed on site. Ensure any
applicable local guidelines or standards regarding locating units on site are
adhered to, such as BS 5839-1 in the UK.
Wherever possible, avoid positioning the unit directly adjacent to metal frames,
electric cables and similar equipment that may interfere with the signal strength.
6
SECURELY FIX THE UNITS IN PLACE
Each WES3 unit must be securely fixed in place and the tamper switch on the
rear of the unit must be in contact with the wall or ceiling.
Detector units are ceiling mounted and intended for indoor use only. Ensure a
risk assessment has been carried out and all reasonable safety precautions are
in place before commencing work.
Call Points must be securely fixed, with the antenna upright, to a robust
vertical surface such as a wall or trolley. Where the existing surface is
unsuitable for direct fixing, use backing board such as plywood or similar sheet
material.
Each unit should be securely mounted using its two integrated mounting points
with M4 x 50mm pan head screws and wall plugs or other fixings selected for
the particular wall or ceiling type.
WES3 CONNECT | RAMTECHGLOBAL.COM/WES/
To Next Page
Loading...
