6
2
ACTIVATE UNITS
To activate any WES3 unit, hold down ‘A’ and press ‘B’ three times in quick
succession. All three LEDs will briefly illuminate and then the amber LED will
flash.
This operation activates the unit – no radio connection is established at this
point.
3
UNIT NUMBERING
Call Points, Detectors, and other WES3 units that are already activated can be
added to create a WES3 network using the Unit Numbering process.
During Unit Numbering, WES3 devices receive details of network configuration
from the WES3 CONNECT unit, including Inspection Delay and Pre Alarm
settings. This is the only way of creating and adding to a WES3 network.
Access the Unit Numbering option on the WES3 CONNECT main menu screen.
This can be accessed by selecting Unit Numbering with the appropriate arrow
next to the screen.
Ensure that any WES3 device to be paired is turned on and has an amber
flashing LED. This indicates the unit is ready to pair.
Units can be numbered any four digit number from 0001 to 9999 in accordance
with your site plan. Numbering allows messages and alerts during operation
to be referenced to a specific unit location on site, using the project site plan.
From the Unit Numbering screen, use the numeric keypad and/or the + and -
buttons to select the desired number for your first unit.
Press and hold ‘A’ on both units. The amber LEDs will illuminate followed
by the green LEDs on both units to indicate that the units have been
successfully paired and a site group created. Release the ‘A’ buttons.
After successfully numbering a unit, change the number displayed on the WES3
CONNECT and repeat the process above for all required units.
If the red LED illuminates, pairing has failed. Ensure the unit to be numbered is
activated, and repeat the Unit Numbering process.
WES3 CONNECT | RAMTECHGLOBAL.COM/WES/
To Next Page
Loading...
