What to do if Ramtech Control Unit Group Flash 5 shows Re-arm or Unit latched?
If your Ramtech Control Unit displays 'Group Flash 5 - Re-arm or Unit latched', you should re-arm the unit according to the operational guidelines.
What to do if Ramtech Control Unit Group Flash 4 shows Tamper?
If your Ramtech Control Unit displays 'Group Flash 4 - Tamper', inspect the unit for any signs of tampering and ensure it is properly secured.
What to do if Ramtech Control Unit Group Flash 3 shows Unpaired?
If your Ramtech Control Unit displays 'Group Flash 3 - Unpaired', you should re-pair the unit following the pairing instructions.
General| Product Type | Wireless Fire Alarm System |
|---|---|
| Operating Frequency | 868 MHz |
| Operating Temperature | -10°C to +55°C |
| Relative Humidity | Up to 95% non-condensing |
| Battery Life | Up to 3 years |
| Power Supply | 3.6V Lithium battery |
| Enclosure Rating | IP65 |
| Communication | Wireless |
| Ingress Protection | IP65 (depending on device) |
Emphasizes safety protocols and legislation during WES³ system installation.
Describes the steps for installing WES³ units and creating a network.
Guides through the initial activation and setup of the WES³ CONNECT unit.
Describes manual and automatic methods for triggering alarms.
Explains how to silence alarms, noting safety precautions.
Details how to reset a latched call point after an alarm.
Details how to start a system test from the CONNECT menu.
Explains how to complete and exit a system test.
Guides through the initial activation and setup of the WES³ Base Station.
Details the Inspection Delay setting for alarm activation timing on Base Station.
Describes the Pre Alarm function and its site-wide behaviour for Base Station.
Explains how to create a WES³ network using units like Base Station.
Details the process of assigning unique numbers to WES³ units via Base Station.
Guides on adding new units to an established WES³ network group via Base Station.
Explains the correct method for securely mounting WES³ units.
Outlines the procedure for performing a system alarm test using Base Station.
Details how the Base Station displays, processes, and silences alarms.
Covers changing access codes and numbering WES³ units via Base Station.
To Next Page
