Ramtech WES3 - Alarm

Page 18 WES
3
Installation and Operations Manual V2.0 Ramtech Electronics Limited 2020
Select ‘Yes’, and enter your access code when requested. During
the re-arming period the following message will be displayed for two
minutes.
At the end of the re-arming period the CONNECT unit will return to the
home screen unless any system warnings have been received during
therealarmorre-armperiod.
System Warnings
The WES
3
CONNECT will indicate warnings from itself or any other
system unit. When a warning is received the screen will be illuminated
and the unit will beep periodically.
Some warnings, for example EXT, will self-clear if the fault is resolved.
Alarm
When an alarm has been raised by a Call Point or Detector, the
CONNECTunitwillashtheLCDdisplay,beepanddisplay“ALARM
ALARM ALARM” together with which units raised the alarm. The
newest event will be at the top of the list.
Unitsareidentiedbyunitnumberandunittype.FindicatesaCall
Point, I an Interface and D a Detector. For example, the above shows
that a Call Point with the number 005 was activated at 08:38 on the 5th
August.
An alarm can be silenced in three ways:
i) Resetting a Call Point
ii) Waiting 30 minutes after the last activation
iii) Using your access code to silence the alarm from the CONNECT
unit
iv)ASensornolongerdetectssmoke/heatandwillstopthealarm
To silence the alarm from the CONNECT unit, press
R during the
alarm. This will take you to the Silence Alarm screen.
Advanced
CONNECT Operation