Ramtech WES3 - Test Phone Number; GSM Status

Page 40 WES
3
Installation and Operations Manual V2.0 Ramtech Electronics Limited 2020
Pressentertoconrmandtheneditthephonenumberinthesame
way.
The telephone number must be in international format with a
+ and then the country code.
For the UK the country code is +44. E.g. a mobile telephone number of
07806123456 would be entered as +447806123456, the starting 0 of
the telephone number is dropped.
TheSMSNoticationsMenucanbeusedtoselectwhicheventsthe
user is interested in. A tick will result in a message being sent for that
particular event
Thenoticationsareshownbelow,NNNistheunitnumberoftheunit
with a fault warning.
1 Alarm
Arealarmhasbeenraisedonthe
site, initiated by unit number NNN
2.
Internal tamper
Unit NNN has been opened up
and potentially tampered with or
damaged
3. Detector tamper
Detector unit NNN has had its
detector head removed
4. External tamper
Unit NNN has been removed from
thewall/ceiling
5. Low battery Unit NNN has low battery
6.
Low signal Unit NNN has a low radio signal
7.
System test Unit NNN has initiated a system test
8. Medical assist
Medical assistance required at Unit
NNN
9. Removed
Unit NNN has been deactivated and
removedfromtherealarmsystem
10. Latched
The call point on unit NNN is latched
in after the alarm has been reset
Test Phone Number
Thenaloptionintheusermenuistotestthephonenumber.
Note: the base station cannot check whether the text message has
arrived at the mobile telephone, just that it is delivered to the network.
Itisimportanttoconrmthatthemessagehasactuallyarrivedatthe
mobile telephone.
GSM Status
The status of the connection to a mobile telephone network can be
checked via the GSM Status option. Note that the modem is switched
off when not in use to conserve battery power, so this check can take a
few minutes to complete.
The screen will initially display…
…and then move to….
…thennallydisplay…
Communications