Ramtech WES3 - WES Warning Code Guide; Base Station Controls

Page 35 WES
3
Installation and Operations Manual V2.0 Ramtech Electronics Limited 2020
It is not possible to exit the warning screen until all warnings have
either been resolved or acknowledged by an authorised user.
To acknowledge a warning, select it with the navigation pad and press
enter.Youwillneedtoenteryouraccesscodefortherstwarningyou
acknowledge.
Base Station Controls
The navigation pad, shown below, is used to move between menus,
change characters and select entries.
Menu items can be selected using the up and down arrows and then
pressing enter (middle arrow button).
Change characters using the up and down arrows while the character
is highlighted.
WES Warning Code Guide
Warning Code Warning Description Self-Clearing SMS Setting
MED Medical Assist Medical assistance required at Unit NNN No 8
BAT Low Battery Unit NNN has a low battery No 5
DET Detector Tamper Unit NNN has had detector head removed Yes 3
EXT External Tamper UnitNNNhasbeenremovedfromwall/ceiling Yes 4
FLT Flat Battery UnitNNNhasturnedoff,itsbatteryisat No 5
INT Internal Tamper Unit NNN has been opened No 2
LAT Latched Call point button on unit NNN is still depressed Yes 10
REM Removed Unit NNN has been deactivated and removed No 9
SIG Low Signal Unit NNN has a low radio signal Yes 6
TST System test Unit NNN initiated a System test Yes 7
NEW Unexpected unit Unit NNN added since last system poll No
GON Unit missing Unit NNN removed since last system poll No
Scroll through characters by holding down the up or down arrows.
Movetothenextcharacteroreldusingtherightarrow.
Use the left arrow button to move to a previous character.
To exit a menu, move to the left-most character and press the left
arrow key again.
Home Screen
Pressing enter on the home screen opens the main menu, giving
access to the System Log Menu and the Settings Menu. The settings
are only available to authorised users with an access code.
If the Base Station has not yet been paired, it will display ‘Unpaired’
instead of the site name.
Unpaired
23/06/17 2 2 : 0 3
02 Minute Delay On
Prealarm mode - On
Advanced
Base Station Operation