Ramtech WES3 - Moving a Unit on Site; Removing a Unit from the Site

Page 32 WES
3
Installation and Operations Manual V2.0 Ramtech Electronics Limited 2020
After moving a unit, we recommend that you conduct a system test
to check that the movement has not adversely affected radio
communication.Ensureanysitereplansareupdatedwithany
revisions to WES
3
unit numbering and location.
Beforeshippingaunitormovingittoanothersiteitmustrstbe
deactivated, in order to:
• prevent accidental triggering
• preserve battery unit life
• clear site information which would prevent it forming or joining
another site
First,removetheunittobedeactivatedfromthewall/ceilingand
ensure the back tamper button is not pressed in.
Hold down ‘A’ and then press ‘B’ three times in quick succession. All
threeLEDswillbrieyilluminateandthenswitchoff.
Note:unitscannotbedeactivatedwhilearealarmisactive.
Moving a Unit on Site
Removing a Unit from Site