R&S FSV3030 Security Procedures

Types of Memory and Information Storage in the R&S FSV/A
R&S
®
FSVA3000 / R&S
®
FSV3000
5Instrument Security Procedures 1179.0097.02 ─ 01
Instrument declassification
The term "instrument declassification" refers to procedures that must be undertaken
before an instrument can be removed from a secure environment, for example when
the instrument is returned for calibration. Declassification procedures include memory
sanitization or memory removal, or both. The declassification procedures described in
this document are designed to meet the requirements specified in DoD 5220.22-M,
"National Industrial Security Program Operating Manual (NISPOM)", Chapter 8.
4 Types of Memory and Information Storage
in the R&S FSV/A
The R&S FSV/A Signal and Spectrum Analyzers contain various memory components.
The following table provides an overview of the memory components that are part of
your instrument. For further information, refer to the subsequent sections.
Table 4-1: Information on memory types
Memory type Size Content Volatility User
Data
Sanitization procedure
SDRAM
(CPU board)
8 Gbyte (IPC11/1)
or
16 Gbyte (IPC11/4)
or
16 Gbyte (IPS14)
Temporary information storage for
operating system and instrument
firmware
Volatile Yes Turn off instrument power
SDRAM
(motherboard)
2 Gbyte Measurement data Volatile Yes Turn off instrument power
SDRAM
(option R&S FSV3-
B200/-B400)
6 Gbyte
EEPROM
(smart card)
≤ 1 Mbyte
Module-specific data:
●
Serial number
●
Product options
●
Board internal correction
data
Non-volatile No None required (no user
data)
Flash
(CPU board)
8 Mbyte (IPC11/1)
or
8 Mbyte (IPC11/4)
or
8 Mbyte (IPS14)
BIOS Non-volatile No None required (no user
data)
Flash
(frontend)
4 Mbyte
Module-specific data:
●
Serial number
●
Product options
●
Board internal correction
data
●
FPGA bitstream data
Non-volatile No None required (no user
data)
Flash
(microwave con-
verter)
4 Mbyte

R&S FSV3030 Specifications

General

Brand	R&S
Model	FSV3030
Category	Measuring Instruments
Language	English