Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
1152User Manual 1178.8520.02 ─ 01
ON | 1
Switches the function on
*RST: 0
Example:
INST:COUP:GEN:STAT ON
INST:COUP:GEN:RLEV:STAT ON
Manual operation: See "Reference level" on page 639
INSTrument:COUPle:GENerator:STATe <State>
Enables or disables coupling between the R&S FSV/A and a connected signal genera-
tor.
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
*RST: 0
Example:
INST:COUP:GEN:STAT ON
Manual operation: See "Coupling State" on page 639
14.11 Using the Status Register
For more information on the contents of the status registers see:
●
"STATus:OPERation Register" on page 671
●
"STATus:QUEStionable:ACPLimit Register" on page 673
●
"STATus:QUEStionable:EXTended Register" on page 674
●
"STATus:QUEStionable:FREQuency Register" on page 675
●
"STATus:QUEStionable:LIMit Register" on page 676
●
"STATus:QUEStionable:LMARgin Register" on page 676
●
"STATus:QUEStionable:POWer Register" on page 677
●
"STATus:QUEStionable:TEMPerature Register" on page 678
●
"STATus:QUEStionable:TIMe Register" on page 678
● General Status Register Commands...................................................................1153
● Reading Out the CONDition Part........................................................................ 1153
● Reading Out the EVENt Part...............................................................................1154
● Controlling the ENABle Part................................................................................1154
● Controlling the Negative Transition Part..............................................................1155
● Controlling the Positive Transition Part............................................................... 1156
Using the Status Register
To Next Page
