R&S RTO - Original Attributes

Reference Waveforms
R&S
®
RTO
213User Manual 1316.0827.02 ─ 06
"Adjust to X-
Axis"
The current horizontal settings of the diagram are used.
"Original Scal-
ing"
Horizontal scaling and reference point of the source waveform are
used.
SCPI command:
REFCurve<m>:HMODe on page 594
Horizontal Stretching
Stretching changes the display of the waveform independent of the horizontal settings of
the source waveform and of the horizontal diagram settings.
Enable ← Horizontal Stretching
Enables and disables the horizontal stretching.
SCPI command:
REFCurve<m>:RESCale:HORizontal:STATe on page 595
Factor ← Horizontal Stretching
A factor greater than 1 stretches the waveform horizontally, a factor lower than 1 com-
presses the curve.
SCPI command:
REFCurve<m>:RESCale:HORizontal:FACTor on page 595
Offset ← Horizontal Stretching
Moves the waveform horizontally. Enter a value with a time unit suitable for the time scale
of the diagram. Positive values shift the waveform to the right, negative values shift it to
the left.
SCPI command:
REFCurve<m>:RESCale:HORizontal:OFFSet on page 595
7.2.3 Original Attributes
As a reference waveform can be scaled, stretched and positioned in the diagram, this
tab shows the settings of the original reference waveform for information.
Reference Waveforms