R&S RTO - Acquisition and Setup

Remote Control
R&S
®
RTO
427User Manual 1316.0827.02 ─ 06
Parameters:
<Format> ASCii | REAL
ASCii
Data values are returned in ASCII format.
REAL
Binary data values are written to a file.
*RST: ASCii
<Length> The length is 0 for ASCII format, and 32 if Format = REAL.
Usage: SCPI confirmed
FORMat:
BPATtern <BitPatternFormat>
Sets the format for all bit pattern queries.
Parameters:
<BitPatternFormat> DEC | HEX | OCT | BIN | ASCII | STRG
*RST: HEX
Firmware/Software: V 1.25
SYSTem:LANGuage <SCPIEmulation>
Defines the remote control behavior of the instrument and sets the remote control com-
mand set.
Parameters:
<SCPIEmulation> SCPI | DPO7000 | TDS540
DPO7000 | TDS540
Compatible remote command set of Tektronix oscilloscopes
DPO7000 or TDS540 is used. If one of these emulation modes is
used, you can define alternative responses to the IDN*? and
OPT*? commands on the SETUP > "Remote settings" tab.
SCPI
R&S RTO remote command set is used.
*RST: SCPI
Firmware/Software: V 1.35
Options: R&S RTO-K301
16.2.5 Acquisition and Setup
● Starting and Stopping Acquisition.........................................................................428
● Time Base.............................................................................................................428
● Acquisition.............................................................................................................430
● Vertical..................................................................................................................436
● Waveform Data.....................................................................................................440
Command Reference