R&S RTO - Mask Testing

Remote Control
R&S
®
RTO
597User Manual 1316.0827.02 ─ 06
Usage: Query only
SCPI confirmed
REFCurve<m>:DATA[:VALues]?
Returns the data of the channel waveform points. The waveform data can be used in
MATLAB, for example.
To set the export format, use FORMat[:DATA].
Suffix:
<m>
.
1..4
Reference waveform
Return values:
<Data> Comma-separated value list of vertical values - voltages, or mag-
nitudes of a spectrum.
Usage: Query only
16.2.12 Mask Testing
● Mask Test Definition..............................................................................................597
● Mask Definition: User Mask..................................................................................600
● Mask Definition: Waveform Mask..........................................................................605
● Event Actions........................................................................................................607
● Results..................................................................................................................608
16.2.12.1 Mask Test Definition
MTESt:ADD...................................................................................................................597
MTESt:REMove.............................................................................................................598
MTESt[:STATe]..............................................................................................................598
MTESt:RST...................................................................................................................598
MTESt:SOURce.............................................................................................................598
MTESt:CONDition..........................................................................................................599
MTESt:TOLerance.........................................................................................................599
MTESt:CTYPe...............................................................................................................599
MTESt:ADD <MaskTestName>
Creates a new mask test definition with the specified name.
Setting parameters:
<MaskTestName>
Usage: Setting only
SCPI confirmed
Command Reference