R&S RTO - Page 444

Remote Control
R&S
®
RTO
428User Manual 1316.0827.02 ─ 06
● Probes...................................................................................................................441
● Digital Filter...........................................................................................................450
● Skew.....................................................................................................................451
●
Reference (OCXO Option R&S RTO)-B4.............................................................452
16.2.5.1 Starting and Stopping Acquisition
RUNContinous...............................................................................................................428
RUN.............................................................................................................................428
RUNSingle....................................................................................................................428
SINGle..........................................................................................................................428
STOP...........................................................................................................................428
RUNContinous
RUN
Starts the continuous acquisition.
Usage:
Event
Asynchronous command
RUNSingle
SINGle
Starts a defined number of acquisition cycles. The number of cycles is set with 
ACQuire:COUNt.
Usage:
Event
Asynchronous command
STOP
Stops the running acquistion.
Usage:
Event
Asynchronous command
16.2.5.2 Time Base
TIMebase:SCALe...........................................................................................................429
TIMebase:RANGe..........................................................................................................429
TIMebase:DIVisions.......................................................................................................429
TIMebase:POSition........................................................................................................429
TIMebase:REFerence.....................................................................................................430
TIMebase:ROLL:ENABle................................................................................................430
TIMebase:ROLL:MTIMe..................................................................................................430
Command Reference