R&S RTO - Page 628

Remote Control
R&S
®
RTO
612User Manual 1316.0827.02 ─ 06
Example:
See "Searching for a pulse of specified width" on page 611
Usage: Setting only
SCPI confirmed
SEARch:CLEar <SearchName>
Clears the search results once to start a new search.
Setting parameters:
<SearchName> Search definition
Usage: Setting only
SEARch:REMove <Key>
Deletes the specified search definition.
Setting parameters:
<Key> Name of the search definition
Usage: Setting only
SCPI confirmed
SEARch:ALL <SearchName>
Performs a search for all results on the existing data from the selected source.
Setting parameters:
<SearchName> Search definition
Example:
See "Searching for a pulse of specified width" on page 611
Usage: Setting only
Asynchronous command
SEARch:NEXT <SearchName>
Performs a single search for the next result on the existing data from the selected source.
Setting parameters:
<SearchName> Search definition
Usage: Setting only
Asynchronous command
SEARch:ONLine <SearchName>,<OnlineState>
SEARch:ONLine? <SearchName>
If enabled, a search is performed repeatedly for each new data acquisition.
Command Reference