R&S RTO - Page 64

Acquisition and Setup
R&S
®
RTO
48User Manual 1316.0827.02 ─ 06
SCPI commands:
● PROBe<m>:ID:SWVersion on page 448
● PROBe<m>:ID:PRDate on page 448
● PROBe<m>:ID:PARTnumber on page 448
● PROBe<m>:ID:SRNumber on page 448
2.3.3.3 Calibration Results
The "Calibration Results" tab provides the calibration data stored in the probe for all R&S
probes connected to an input channel.
Attenuation
Shows the attenuation of the probe. This value is also shown in the "Setup" tab.
2.3.3.4 Service
The "Service" tab supports the update of the probe's firmware, provides a selftest and
other functions that are useful in case of service.
Probe FW update
A new firmware for R&S probes is delivered together with the R&S RTO firmware. To
install the new probe firmware, you download it from the instrument to the probe.
Note: The installation of a new firmware resets all settings.
●
Select the firmware package with "Select FW update package".
●
Tap "Flash it!".
Reference for Acquisition and Setup