R&S RTO - Page 747

Remote Control
R&S
®
RTO
731User Manual 1316.0827.02 ─ 06
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<BSSError> ON | OFF
*RST: ON
TRIGger<m>:FLXRay:FESerror <FESError>
Triggers on error in Frame End Sequence. FES indicates the end of each frame.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<FESError> ON | OFF
*RST: ON
TRIGger<m>:FLXRay:FSSerror <FSSError>
Triggers on Error in a Frame Start Sequence. FSS follows the Transmission Start
Sequence TSS at the beginning of each frame.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<FSSError> ON | OFF
*RST: ON
TRIGger<m>:FLXRay:HCRCerror <CRCHeaderError>
Triggers on error in the Cyclic Redundancy Check of the header data (mainly frame ID
and payload length).
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<CRCHeaderError> ON | OFF
*RST: ON
TRIGger<m>:FLXRay:PCRCerror <CRCPayloadError>
Triggers on error in the Cyclic Redundancy Check of the payload data.
Command Reference