R&S
®
SMB100A Information on the current version and history
Release Notes 1234.5678.02 - 01 7
1.4 Version 3.20.390.24
Released January 2016
New functionality
Support of new NRPxS(N) Power Sensors
Support of new frequency options SMB-B140N and SMB-B131
Calibration value of oscillator can be changed using protection level 2
Improved FM deviation for stereo modulation up to 200 kHz
Sweep will be stopped after modification of the sweeped value e.g. RF frequency
Factory Preset of "RF OFF Mode" depends on the installed hardware features.
Devices with a mechanical step attenuator => "Full Attenuation"
Devices without a mechanical step attenuator => "Unchanged"
Step attenuator bouncing with ALC mode S&H at RF output
Pulse Train repetition was not updated after editing
In rare cases a message "Command header too long" was incorrectly displayed
RF output power was not adjusted properly after pulse modulator activation
Repeated settings of the RF phase results in an increased setting time
To Next Page
Loading...