2 Information on Remote Emulations
The R&S®SMB100A signal generators offer a remote emulation feature that makes it
possible to control the instrument by commands other than the built-in native SCPI
commands. This feature allows the user to replace signal generators, e.g. from other
manufacturers, with the R&S®SMB100A without having to change the remote control
code.
All of the subsequent emulations are available regardless of the configuration of the
instrument. In order to meet the frequency range of the emulated instruments, the table
points out recommended options.
Further information regarding this feature can be obtained from
www.rohde-schwarz.com.
Firmware version Fehler! Unbekannter Name für Dokument-Eigenschaft. supports
the following remote emulations:
To Next Page
Loading...
Need help?
General