R&S ZNA26 - Page 1245

Command reference
R&S
®
ZNA
1245User Manual 1178.6462.02 ─ 20
Suffix:
<Ch>
.
Channel number of the calibrated channel.
<PhyPt> Physical port number, used to select a specific frequency axis in
arbitrary mode (with option R&S ZNA-K4).
Parameters:
<ErrorTerm> String parameters describing the different error terms, depend-
ing on the current calibration method; see table below. Each
term contains one complex value (real and imaginary part) for
each sweep point. The parameters must be transferred in full
length. The following strings are allowed:
'DIRECTIVITY'
Directivity at source port <SourcePort>
'SRCMATCH'
Source match at source port <SourcePort>
'REFLTRACK'
Reflection tracking at source port <SourcePort>
'LOADMATCH'
Load match at load port <LoadPort>
'TRANSTRACK'
Transmission tracking between source port <SourcePort> and
load port <LoadPort>.
'G11' ... 'G22'
G matrix elements at source port <SourcePort>; see explanation
above.
'H11' ... 'H22'
H matrix elements at load port <LoadPort>; see explanation
above.
'Q11' ... 'Q22 ', 'PREL'
9-term correction factors, defined at source port <SourcePort>;
<LoadPort> is ignored
‘PABS’
9-term correction factors, defined for the lowest source port
<SourcePort> for each SMARTerCal; <LoadPort> is ignored
'L1', 'L2'
9-term correction factors, defined between the source port
<SourcePort> and the load port <LoadPort>
Range:
The error terms are dimensionless complex num-
bers.
*RST: n/a
<SourcePort> Source port number
<LoadPort> Load port number. If the error term is not related to the load port,
a dummy number can be used; e.g. CORR:CDAT
'REFLTRACK', 1, 0
SCPI command reference