Command reference
R&S
®
ZNA
1246User Manual 1178.6462.02 ─ 20
<CorrectionData> Correction data set (one complex number per sweep point) to be
transferred to the analyzer either in ASCII or block data format,
depending on the current FORMat[:DATA] setting. The correc-
tion data set is assigned to the specified channel, error term,
source and load port.
This parameter must not be used for queries.
Example: See [SENSe<Ch>:]CORRection:COLLect:SAVE:
SELected:DEFault.
The different calibration types of the analyzer provide the following error terms:
Calibration type Parameters in
[SENSe<Ch>:]CORRection:
COLLect:METHod:DEFine
Available error terms (depending on port num-
bers)
One-port normalization (reflection)
using an open or a short standard
REFL, RSHort 'REFLTRACK'
Full one port ("Refl OSM") FOPort 'DIRECTIVITY', 'SRCMATCH', 'REFLTRACK'
Two-port normalization FRTRans 'TRANSTRACK'
One path two port OPTPort 'DIRECTIVITY', 'SRCMATCH', 'REFLTRACK',
'TRANSTRACK'
TOSM TOSM 'DIRECTIVITY', 'SRCMATCH', 'REFLTRACK',
'LOADMATCH', 'TRANSTRACK'
TOM, TSM, TRM, TRL, TNA TOM | TSM | TRM | TRL | TNA 'DIRECTIVITY', 'SRCMATCH', 'REFLTRACK',
'LOADMATCH', 'TRANSTRACK' (for reading and
writing)
'G11' ... 'G22' and 'H11', 'H12', 'H22' (for reading
only; the 'H21' matrix elements are normalized to
1)
7.3.14.7 [SENSe:]CORRection:CKIT...
The [SENSe:]CORRection:CKIT... commands deal with calibration kits and cal kit
data. The calibration kits are distinguished by their names (<CalkitName>), the optional
labels (<label>) can be used to carry information about the calibration standard.
In order to handle several identical calibration kits with different serial numbers use the
commands of Chapter 7.3.14.8, "[SENSe:]CORRection:CKIT... with Labels",
on page 1254.
[SENSe:]CORRection:CKIT:CATalog?............................................................................ 1247
[SENSe:]CORRection:CKIT:DELete............................................................................... 1247
[SENSe:]CORRection:CKIT:DMODe.............................................................................. 1247
[SENSe:]CORRection:CKIT:LABel................................................................................. 1248
[SENSe:]CORRection:CKIT:SELect............................................................................... 1248
[SENSe:]CORRection:CKIT:STANdard:CATalog?............................................................ 1249
[SENSe:]CORRection:CKIT:STANdard:DATA?................................................................ 1249
[SENSe:]CORRection:CKIT:<ConnType>:SELect............................................................ 1250
[SENSe:]CORRection:CKIT:<StandardType>.................................................................. 1251
SCPI command reference
To Next Page
Loading...
