Command reference
R&S
®
ZNA
1324User Manual 1178.6462.02 ─ 20
[SENSe<Ch>:]FREQuency:IMODulation:TDIStance........................................................ 1340
[SENSe<Ch>:]FREQuency:IMODulation:UTONe.............................................................1340
[SENSe<Ch>:]FREQuency:SBANd................................................................................1341
[SENSe<Ch>:]FREQuency:SEGMent:AXIS.................................................................... 1342
[SENSe<Ch>:]FREQuency:SPAN..................................................................................1342
[SENSe<Ch>:]FREQuency:STARt................................................................................. 1343
[SENSe<Ch>:]FREQuency:STOP..................................................................................1343
[SENSe<Ch>:]FREQuency[:CW] <FixedFreq>
[SENSe<Ch>:]FREQuency:FIXed <FixedFreq>
Defines the fixed (Continuous Wave, CW) frequency for all sweep types operating at
fixed frequency ("Power", "Time", "CW Mode"). The two command forms
[SENSe<Ch>:]FREQuency[:CW] and [SENSe<Ch>:]FREQuency:FIXed are
equivalent.
This command also defines the center frequency of the intermodulation spectrum dia-
gram (with option R&S ZNA-K4). The frequency range depends on the R&S ZNA
model; see Chapter 7.3.14.12, "[SENSe:]FREQuency...", on page 1323.
Note:[SENSe<Ch>:]FREQuency[:CW]|:FIXed is equivalent to
SOURce<Ch>:FREQuency<PhyPt>[:CW]|:FIXed. Source and receiver frequency
are always equal; the four commands overwrite each other.
With option R&S ZNA-K4, Frequency Conversion Measurements, port-specific source
and receiver frequencies can be defined; see SOURce<Ch>:FREQuency<PhyPt>:
CONVersion:ARBitrary:IFRequency.
Suffix:
<Ch>
.
Channel number
Parameters:
<FixedFreq> Fixed stimulus and analyzer frequency
*RST: 1 GHz
Default unit: Hz
Example:
FUNC "XTIMe:POW:A1"
Activate a time sweep and select the wave quantity a
1
as mea-
sured parameter for channel and trace no. 1.
FREQ:CW 100MHz
Set the CW frequency to 100 MHz.
Manual operation: See "CW Frequency" on page 475
[SENSe<Ch>:]FREQuency:COMPression:POINt <CompVal>
Defines the compression value for a gain compression measurement in channel <Ch>.
The gain compression measurement searches for the <CompVal> dB compression
points.
Suffix:
<Ch>
.
Channel number
SCPI command reference
To Next Page
Loading...
