R&S ZNA26 - Page 1335

Command reference
R&S
®
ZNA
1335User Manual 1178.6462.02 ─ 20
[SENSe<Ch>:]FREQuency:CONVersion:MIXer:RFMultiplier <Numerator>,
<Denominator>
Selects the frequency conversion factor for the RF signal. The conversion factor is a
ratio of two positive integers (numerator, denominator).
Suffix:
<Ch>
.
Channel number
Parameters:
<Numerator>
Range: 1, 2, 3 ...
*RST: 1
<Denominator> Range: 1, 2, 3 ...
*RST: 1
Example: See [SENSe<Ch>:]FREQuency:CONVersion:MIXer:
MFFixed
Manual operation: See "Multiplication factors" on page 364
[SENSe<Ch>:]FREQuency:CONVersion:MIXer:RFPort <Port>
Selects a test port as source port for the RF signal.
Suffix:
<Ch>
.
Channel number
Parameters:
<Port> Test port number
Range: 1 to number of test ports
*RST: 1
Example: See [SENSe<Ch>:]FREQuency:CONVersion:MIXer:
MFFixed
Manual operation: See "Port selection" on page 364
[SENSe<Ch>:]FREQuency:CONVersion:MIXer:STAGes <Stages>
Selects the number of mixer stages for scalar mixer measurements.
Suffix:
<Ch>
.
Channel number
Parameters:
<Stages> Number of mixer stages
Range: 1 | 2
*RST: 1
Example: See [SENSe<Ch>:]FREQuency:CONVersion:MIXer:
MFFixed
Manual operation: See "RF, IF and Mixer Stages" on page 365
SCPI command reference