R&S ZNA26 - Page 1333

Command reference
R&S
®
ZNA
1333User Manual 1178.6462.02 ─ 20
Parameters:
<Numerator>
Range: 1, 2, 3 ...
*RST: 1
<Denominator> Range: 1, 2, 3 ...
*RST: 1
Example: See [SENSe<Ch>:]FREQuency:CONVersion:MIXer:
MFFixed
Manual operation: See "Multiplication factors" on page 364
[SENSe<Ch>:]FREQuency:CONVersion:MIXer:LOPort<Stg> <SourceType>[,
<SourceNumber>]
Selects an analyzer or an external generator port as a signal source for the LO1 or
LO2 signal.
Suffix:
<Ch>
.
Channel number
<Stg> Mixer stage (signals LO 1 or LO 2; see [SENSe<Ch>:
]FREQuency:CONVersion:MIXer:STAGes).
Parameters:
<SourceType> PORT | GENerator | NONE
NONE – LO signal is not controlled by the analyzer.
PORT – analyzer port
GENerator – external generator
*RST: NONE
<SourceNumber> Number of analyzer port or generator.
Example: See [SENSe<Ch>:]FREQuency:CONVersion:MIXer:
MFFixed
Manual operation: See "Port selection" on page 364
[SENSe<Ch>:]FREQuency:CONVersion:MIXer:MFFixed <InputOutput>[,
<FixedFrequency>]
Assigns a fixed frequency to the RF, LO 1, LO 2, or to the IF signal. The fixed fre-
quency setting becomes active if the port is selected as a port with fixed frequency
([SENSe<Ch>:]FREQuency:CONVersion:MIXer:FIXed<Stg>).
Suffix:
<Ch>
.
Channel number
Parameters:
<InputOutput> RF | LO | LO1 | LO2 | IF
Fixed frequency for the specified port
RF – mixer input signal
LO | LO1 – local oscillator signal no. 1
SCPI command reference