Command reference
R&S
®
ZNA
1396User Manual 1178.6462.02 ─ 20
Options: R&S ZNA-K1
Manual operation: See "Image Rejection" on page 354
[SENSe<Ch>:]SPECtrum:ZPADing <Boolean>
Disables/enables zero padding.
Suffix:
<Ch>
.
Channel number
Parameters:
<Boolean> 1 (ON)
Zero padding used (higher level accuracy)
0 (OFF)
Zero padding used (higher level accuracy, in particular for multi-
channel measurements)
*RST: 1 (ON)
Options: R&S ZNA-K1
Manual operation: See "Increased Level Accuracy" on page 354
7.3.14.27 [SENSe:]SWEep...
The [SENSe:]SWEep... commands provide general settings to control the sweep.
Most of the settings have an impact on the sweep time.
[SENSe:]SWEep:COUNt:ALL........................................................................................1397
[SENSe<Ch>:]SWEep:AXIS:FREQuency....................................................................... 1397
[SENSe<Ch>:]SWEep:AXIS:POWer.............................................................................. 1398
[SENSe<Ch>:]SWEep:COUNt.......................................................................................1399
[SENSe<Ch>:]SWEep:CTIMing:STIMe.......................................................................... 1399
[SENSe<Ch>:]SWEep:CTIMing:STIMe:MODE................................................................1400
[SENSe<Ch>:]SWEep:DETector:TIME........................................................................... 1400
[SENSe<Ch>:]SWEep:DWELl....................................................................................... 1401
[SENSe<Ch>:]SWEep:DWELl:IPOint............................................................................. 1401
[SENSe<Ch>:]SWEep:FPOWer.....................................................................................1402
[SENSe<Ch>:]SWEep:GENeration................................................................................ 1402
[SENSe<Ch>:]SWEep:POINts.......................................................................................1402
[SENSe<Ch>:]SWEep:REVerse.................................................................................... 1403
[SENSe<Ch>:]SWEep:STEP.........................................................................................1403
[SENSe<Ch>:]SWEep:TIME......................................................................................... 1404
[SENSe<Ch>:]SWEep:TIME:AUTO................................................................................1405
[SENSe<Ch>:]SWEep:TIME:MODE...............................................................................1405
[SENSe<Ch>:]SWEep:TYPE.........................................................................................1406
[SENSe<Chn>:]SWEep:SRCPort...................................................................................1407
SCPI command reference
To Next Page
Loading...
