R&S ZNA26 - Page 1420

Command reference
R&S
®
ZNA
1420User Manual 1178.6462.02 ─ 20
<LogPt> Logical port number used to number balanced ports.
Range according to the current port configuration
(SOURce<Ch>:LPORt<LogPt>). If an undefined balanced port
number is used, the analyzer generates an error message.
Exception: Parameter ALL, see below.
Setting parameters:
<Scope> ALL
If ALL is specified, all logical ports are dissolved; the <log_port>
suffix is ignored. If ALL is omitted, only the specified balanced
port is dissolved.
Example: See SOURce<Ch>:LPORt<LogPt>
Usage: Setting only
Manual operation: See "Select Predefined Port" on page 312
7.3.15.5 SOURce:GROup...
The SOURce:GROup... commands define the group of (un-)used logical ports.
SOURce<Ch>:GROup:COUNt?.....................................................................................1420
SOURce<Ch>:GROup<Grp>........................................................................................ 1420
SOURce<Ch>:GROup<Grp>:CLEar.............................................................................. 1421
SOURce<Ch>:GROup<Grp>:NAME.............................................................................. 1421
SOURce<Ch>:GROup<Grp>:PORTs............................................................................. 1422
SOURce<Ch>:GROup<Grp>:PPORts............................................................................1422
SOURce<Ch>:GROup<Grp>:SIMultaneous:FOFFset:STATe............................................ 1422
SOURce<Ch>:GROup<Grp>:SIMultaneous:FOFFset:MOFFset:MODE............................. 1425
SOURce<Ch>:GROup<Grp>:SIMultaneous:FOFFset:MOFFset:DVALue........................... 1426
SOURce<Ch>:GROup<Grp>:SIMultaneous:FOFFset:MOFFset:BWFactor........................ 1426
SOURce<Ch>:GROup<Grp>:SIMultaneous:FOFFset:CONDition......................................1427
SOURce<Ch>:GROup:COUNt?
Queries the number of port groups in channel no. <Ch>.
Suffix:
<Ch>
.
Channel number.
Example: See SOURce<Ch>:GROup<Grp> on page 1420
Usage: Query only
Manual operation: See "Controls and Functions" on page 628
SOURce<Ch>:GROup<Grp> <arg0>, <arg1>
In "set direction" this command defines the set of active logical ports (the "master
group") as the continuous range from <log_port1> to <log_port2>, i.e. logical
ports outside this range are disabled.
SCPI command reference