R&S ZNA26 - Page 1433

Command reference
R&S
®
ZNA
1433User Manual 1178.6462.02 ─ 20
SOURce<Ch>:POWer<Pt>:ALC:PIParameter:ITIMe <Alc control loop coefficients
itime>
Defines the integration time of the ALC PI controller at source port <Pt> in channel
<Ch>.
This setting only takes effect if SOURce<Ch>:POWer<Pt>:ALC:PIParameter is set
to MANual.
Suffix:
<Ch>
.
Channel number
<Pt> Port number
Parameters:
<Value> Integration time Ki [s]
Range: 1E-8 to 1E2
*RST: 0.4
Manual operation: See "Control Loop Parameters" on page 482
SOURce<Ch>:POWer<Pt>:ALC:RANGe <CRange>
Defines the maximum change of the source signal level due to the ALC for physical
port <Pt> in channel <Ch>.
Suffix:
<Ch>
.
Channel number
<Pt> Port number
Parameters:
<CRange> Control range [dB]
Range: 0 to 100
Increment: 0.1
*RST: 5
Manual operation: See "Control Range +/-" on page 479
SOURce<Ch>:POWer<Pt>:ALC:RECeiver <ALCReceiver>
Defines the receiver to be used for ALC at port <Pt> in channel <Ch>.
The target level is taken from the port configuration (SOURce<Ch>:POWer<Pt>:ALC:
TPOWer:DEFault on page 1435 ON) or can be set using SOURce<Ch>:POWer<Pt>:
ALC:TPOWer.
Suffix:
<Ch>
.
Channel number
<Pt> Port number
Parameters:
<ALCReceiver> 'A<n>'
Reference receiver at analyzer port <n>
SCPI command reference