Command reference
R&S
®
ZNA
1443User Manual 1178.6462.02 ─ 20
SOURce<Ch>:POWer:CORRection:DATA:PARameter<Wv>? <SettingType>
Gets settings of the available power calibrations.
Suffix:
<Ch>
.
Number of the calibrated channel.
<Wv> Number of the power calibration.
Use SOURce<Ch>:POWer<PhyPt>:CORRection:DATA:
PARameter<Wv>:COUNt? on page 1451 to query the number
of available power calibrations.
Query parameters:
SettingType WAVE | STARt | STOP | POINts | STYPe | ATTenuation |
CPOWer | CFRequency | TSTamp | LTSTamp | FSMode
WAVE
Calibrated port and calibration type (Gen=Source Power,
Rec=Measurement Receiver)
STARt
Start Frequency or Power
Stop Frequency or Power
POINts
Nr. of sweep points
STYPe
Sweep type or grid (LIN, LOG, SEGM)
ATTenuation
Source or receiver attenuation
CPOWer
Cal Power for frequency sweeps
CFRequency
Cal Frequency for power sweeps
TSTamp
Timestamp in UTC
LTSTamp
Timestamp in local time
Usage:
Query only
Manual operation: See "Port Overview" on page 543
SOURce<Ch>:POWer<PhyPt>:CORRection:HARMonic[:ACQuire]
Starts the source calibration
●
at physical port <PhyPt>
●
in channel <Ch>
●
at harmonic orders [SENSe<Ch>:]CORRection:ADVanced:HARMonic:ORDer?
?
Then stores and applies the calibration data.
SCPI command reference
To Next Page
Loading...
