R&S ZNA26 - Page 1545

Command reference
R&S
®
ZNA
1545User Manual 1178.6462.02 ─ 20
Prerequisites for this command:
●
Select an SNMP version that supports communities (SYSTem:COMMunicate:
SNMP:VERSion on page 1547).
Setting parameters:
<CommunityString> String containing the community name.
Example: //Set community name
SYST:COMM:SNMP:VERS V12
SYST:COMM:SNMP:COMM:RO 'ABC'
Usage: Setting only
Manual operation: See "SNMPv2c Configuration" on page 802
SYSTem:COMMunicate:SNMP:COMMunity:RW <CommunityString>
This command sets the SNMP community string for read-write access.
Prerequisites for this command:
●
Select an SNMP version that supports communities (SYSTem:COMMunicate:
SNMP:VERSion on page 1547).
Setting parameters:
<CommunityString> String containing the community name.
Example: //Set read-write access
SYST:COMM:SNMP:VERS V12
SYST:COMM:SNMP:COMM:RW 'ABC'
Usage: Setting only
Manual operation: See "SNMPv2c Configuration" on page 802
SYSTem:COMMunicate:SNMP:CONTact <SnmpContact>
This command sets the SNMP contact information for the administrator.
You can also set the contact information via SNMP if you do not set it via SCPI.
Parameters for setting and query:
<SnmpContact> String containing SNMP contact.
*RST: "" (empty string)
Example: //Set SNMP contact
SYST:COMM:SNMP:CONT 'ABC'
SYSTem:COMMunicate:SNMP:LOCation <SnmpLocation>
This command sets the SNMP location information for the administrator.
You can also set the location information via SNMP if you do not set it via SCPI.
HUMS and service date commands