GUI reference
R&S
®
ZNA
342User Manual 1178.6462.02 ─ 20
Remote command:
[SENSe<Ch>:]FREQuency:IMODulation:TDIStance
Start delta Freq./Stop delta Freq./Number of Points/Base Power/CW Fre-
quency/CW fixed to
Defines the lower tone and upper tone frequency sweeps for IMD Sweep Type "Delta
F".
Additional channel settings
IF Bandwidth
See "Bandwidth" on page 485.
Step Att Receiving Port
Only available if the selected Receiving Port is equipped with a receiver step attenua-
tor (see Chapter 4.7.30, "Receiver step attenuators", on page 279).
Defines the receiver step attenuation at this port.
Frequency Overview dialog
The "Frequency Overview" dialog summarizes the resulting measured frequency
ranges, according to the current setup of the related channel. Invalid frequency ranges
(that are not covered by the analyzer's frequency range) are marked in red.
Access: "Frequency Overview" in various channel mode setup dialogs
The settings in the channel mode setup dialog from which the "Frequency Overview"
dialog was called cannot be applied unless all measured frequency ranges are valid.
5.2.6.3 Intermodulation setup dialog (frequency-converting)
The frequency converting intermodulation setup dialog is an instance of the Multi-chan-
nel setup dialog. It allows you to set up one or more channels for an intermodulation
measurement on a frequency converting DUT.
Access: Trace – [Meas] ("Frequency Converting") > "Intermodulation" > "Intermod."
Meas softtool
To Next Page
Loading...
