GUI reference
R&S
®
ZNA
389User Manual 1178.6462.02 ─ 20
●
These actions can also be performed from the context menu of the trace name
segment in the trace list (see Chapter 4.2.1.4, "Channel list and channel settings",
on page 107).
●
Use the "On" flags in the "Trace Manager" to show/hide arbitrary sets of traces
(see Chapter 5.5.1.3, "Trace Manager dialog", on page 390).
5.5.1.2 New Trace dialog
The "Trc+" tool bar button allows you to create a trace in the active channel.
●
Tap/click the "Trc+" button to duplicate the active trace (equivalent to Add Trace).
●
Drag the respective button onto the diagram area to create the trace in any other
existing diagram or in a new one.
After the button has been dropped, the "New Trace" dialog pops up and lets you
select the quantity to be measured.
If the active channel is in a non-standard measurement mode, a different "New Trace"
dialog is opened:
●
Intermodulation: see Chapter 5.2.6.4, "Intermodulation Measurements dialog",
on page 343
●
Compression:
●
Spectrum:
Traces softtool
To Next Page
Loading...
