GUI reference
R&S
®
ZNA
458User Manual 1178.6462.02 ─ 20
Define an adequate "Search Range" to restrict the search to the adequate frequency or
power interval (see Chapter 5.7.3.2, "Search Range dialog", on page 458).
Note: Tracking for bandfilter search can be activated separately, see "Tracking"
on page 469.
Remote command:
CALCulate<Chn>:MARKer<Mk>:SEARch:TRACking
Marker Config...
Opens the Marker Config dialog.
Spectrum = Marker
This button is only available if the analyzer is equipped with software option R&S ZNA-
K1 (see Chapter 4.7.1, "Spectrum analyzer mode", on page 220). It is only enabled if
there is at least one marker on the active trace.
In this case it performs the following actions:
●
Create a channel
●
Sets its center to the active marker's position
●
Set its span to 10 times the (previously) active channel's Bandwidth
●
Switch to spectrum mode
Remote command:
CALCulate<Chn>:MARKer<Mk>:FUNCtion:SPECtrum
5.7.3.2 Search Range dialog
The "Search Range" dialog confines the "Marker Search" and "Target Search" for the
selected marker to a subrange of the sweep. The search range is a continuous interval
of the sweep variable.
Access:
●
Trace – [Marker] > "Marker Search" > "Search Range..."
●
Trace – [Marker] > "Target Search" > "Search Range..."
If Tracking is active, the assigned "Search Range" applies to all sweeps and can be
used to achieve uniqueness in "Min", "Max" or "Target Search".
See also Chapter 5.5.8, "Trace Statistics tab", on page 410.
Marker softtool
To Next Page
Loading...
