GUI reference
R&S
®
ZNA
517User Manual 1178.6462.02 ─ 20
Figure 5-21: Select Calibration Properties dialog: vector mixer measurements
5.11.1.2 Controls on the Start Cal tab
All controls on the "Start Cal" are buttons and each of them opens a dialog or dock
widget wizard. The buttons are grouped in three sections.
●
"Cal Active Channel" section
The main purpose of the buttons in this section is to calibrate the current channel.
– "Quick Start Calibration..." immediately starts the calibration of the current
channel, using its current calibration configuration.
Opens the calibration wizard that guides you through the calibration data acqui-
sition.
– "Configure/Start Calibration..." opens the calibration setup dialog, which allows
you to configure the calibration setup of the current channel, and to start the
Cal softtool
To Next Page
Loading...
