R&S ZNA26 - Page 599

GUI reference
R&S
®
ZNA
599User Manual 1178.6462.02 ─ 20
The new channel is named Ch<n>, where <n> is the largest of all existing channel
numbers plus one. The name can be changed in the "Channel Manager" dialog.
Tips:
●
To create a channel and a trace with default settings and to display the trace in a
new diagram area, use New Channel + Diagram.
●
Use Add Trace to create a trace in the active channel.
Remote command:
CONFigure:CHANnel<Ch>[:STATe] ON
CALCulate<Ch>:PARameter:SDEFine
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:FEED
CONFigure:TRACe<Trc>:CHANnel:NAME?
CONFigure:TRACe<Trc>:CHANnel:NAME:ID?
Copy Channel
Copies the active channel with all its settings (including a possible channel calibration)
and traces. The new traces are displayed in the active diagram area.
The new channel is named Ch<n>, where <n> is the largest of all existing channel
numbers plus one. The name can be changed in the "Channel Manager" dialog.
Tips: Use Copy Channel + Diagram to display the copied traces in a new diagram
area.
Remote command:
CONFigure:CHANnel<Ch>[:STATe] ON
CALCulate<Ch>:PARameter:SDEFine
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:FEED
CONFigure:TRACe<Trc>:CHANnel:NAME?
CONFigure:TRACe<Trc>:CHANnel:NAME:ID?
New Channel + Diagram
Creates a channel and a trace with default settings, and assigns the created trace to a
new diagram area.
The new channel is named Ch<n>, where <n> is the largest of all existing channel
numbers plus one. The name can be changed in the "Channel Manager" dialog.
Tip: To create a channel and a trace with default settings and to display the trace in the
active diagram area, use New Channel.
Copy Channel + Diagram
Copies the active channel with all its settings (including a possible channel calibration)
and traces, and displays the created traces in a new diagram area.
The new channel is named Ch<n>, where <n> is the largest of all existing channel
numbers plus one. The name can be changed in the "Channel Manager" dialog.
Tips: Use Copy Channel to display the new traces in an existing diagram area.
Delete Channel
Deletes the current channel including all the traces assigned to it and removes all dis-
play elements related to the channel from the diagram area. "Delete Channel" is dis-
abled if the recall set contains only one channel: In manual control, each recall set
must contain at least one diagram area with one channel and one trace.
Channel Config softtool