GUI reference
R&S
®
ZNA
627User Manual 1178.6462.02 ─ 20
Note that setting "Enter & Display" to a particular port, source, or receiver is only possi-
ble if option R&S ZNA-K4 is available. Furthermore, a particular port, source, or
receiver can only be selected, if the user-defined linear function for calculating the
respective frequency/power is not constant.
5.12.2.3 Define Parallel Measurement dialog
With a 4-port R&S ZNA or a 2-port R&S ZNA with 2nd internal source, you can mea-
sure multiple DUTs (or multiple paths of a single DUT) in parallel. The "Define Parallel
Measurement" dialog allows you to configure these DUTs and to declare the connec-
tions between physical VNA ports and DUT ports. Furthermore it provides convenient
access to port-related settings.
New in firmware version 2.30
On a R&S ZNA with four internal sources, four 1-port DUTs can be measured in paral-
lel.
Related information
See Chapter 4.1.4.2, "Parallel measurements on multiple DUTs", on page 89.
The "Parallel Measurement" is automatically configured when "Enabled" is selected, as
shown in Figure 5-32.
A R&S ZNA with two internal sources allows parallel measurements with "Frequency
Offset", which can be configured in the corresponding tab on the right.
Channel Config softtool
To Next Page
Loading...
