Rane Four - Pitch Play; Saved Loops

19
Pitch Play
To enter Pitch Play mode, quickly double tap this button. In this mode, the
performance pads offer a range of different keys for the active hot cue (adjustable
by semitones). The Serato Pitch N Time plugin (included) must be installed to use
this mode. See Hot Cue to learn how to assign hot cue points.
To enter Pitch Play mode, quickly double tap Hot Cue pad mode button.
To select which hot cue point to use, press and hold Shift and press a dimly lit
Pad.
To select the range of transpositions the pads will use, press the Parameter </>
buttons.
To play the track from the hot cue point, press a lit Pad. Each pad corresponds to a
specific transposition (by semitones), depending on the current range of
transposition.
A pad with no semitone selected will be lit dim. A pad with a semitone selected will
be lit at full brightness. A pad with no transposition (the original pitch) will be lit
white.
Saved Loops
In Saved Loops mode, each pad triggers a loop previously saved in your software.
To enter Saved Loops mode, quickly double tap Roll pad mode button. The pad
LED will be off when no loop is saved to a pad. The LED will be bright Green when a
loop is saved to a pad. The LED will be bright Blue when a saved loop is active.
To play a loop, press a lit Pad. Each deck’s eight pads will correspond to Saved
Loops 1–8 in your software.
To activate the saved loop, press the pad to activate the loop or press and hold
Shift and press the corresponding pad to activate and jump to the loop position in
the track.
To halve the loop size, press the Parameter < button.
To double the loop size, press the Parameter > button.
To move the active loop region backward at the current loop size without
deactivating the loop, press and hold Shift and then press the Parameter < button.
To move the active loop region forward at the current loop size without
deactivating the loop, press and hold Shift and then press the Parameter > button.