20
Scratch Bank
In Scratch Bank mode, each pad loads samples and tracks from your Serato DJ Pro
library to a pad. You can assign the song and set the starting point in the software.
This is useful for preparing and performing with song samples for scratching.
To enter Scratch Bank mode, quickly double tap the Sampler pad mode button.
The pad LED will be off when no track is loaded. The LED will be bright White when
a Scratch Bank track is loaded to a pad. Colors can be set in the Scratch Bank panel
within the Serato DJ Pro software.
To load the selected track to a pad, press an unlit Pad. When that pad is pressed
again, the corresponding track will be loaded to the deck.
To load the track that was previously on the deck before loading a Scratch Bank
track, press and hold Shift and press the corresponding pad.
To cycle the Scratch Bank selection left, press the Parameter < button.
To cycle the Scratch Bank selection right, press the Parameter > button.
Slicer Mode
In Slicer mode, the eight pads represent eight sequential beats (slices) in the
beatgrid. The currently playing slice is represented by the currently lit pad; the light
will “move through the pads” as it progresses through the eight-slice phrase. When
you release the pad, the track will resume normal playback from where it would have
been if you had never pressed it (i.e., as if the track had been playing forward the
whole time).
To enter Slicer mode, quickly double tap the Stems pad mode button. The pad LED
will be bright Red for all sliced pads. The LED will be bright Blue for the playhead
position or current slice. The LED will be bright White while a pad is pressed.
To play a slice, press the corresponding pad.
To halve the slice domain size, press the Parameter < button.
To double the slice domain size, press the Parameter > button.
To Next Page
Loading...
