DST-64T / DST642D Wheel Balancers 10 P/N 5900192 — Rev. F — March 2021
Installation Checklist
Following are the steps needed to install the Balancer. Perform them in the order shown.
☐ 1. Review the installation Safety Rules.
☐ 2. Plan for Electrical Work.
☐ 3. Make sure you have the necessary Tools.
☐ 4. Select the Installation Site.
☐ 5. Make sure there is adequate Clearance on all Sides and Above.
☐ 6. Unpack the Balancer.
☐ 7. Identify the Components on the Back of the Unit.
☐ 8. Install the Display Panel.
☐ 9. Install the Mount Box.
☐ 10. Install the Hood.
☐ 11. Install the Outer Arm (DST-64T only).
☐ 12. Install the Shaft.
☐ 13. Anchor the Unit.
☐ 14. Connect to a Power Source.
Requires a licensed Electrician
.
☐ 15. Test the Balancer.
☐ 16. Review the Final Checklist.
To Next Page
Loading...
