DST-64T / DST642D Wheel Balancers 3 P/N 5900192 — Rev. F — March 2021
Table of Contents
Introduction 3 Operation 2
4
Shipping Information 4 Maintenance 4
6
Safety Considerations 4 Troubleshooting 4
7
Components 6 Wiring Diagram
53
FAQ 8 Labels
54
Specifications 9 Parts 5
6
Installation Checklist 10 Maintenance Log
78
Installation 11
Introduction
This manual describes the following Wheel Balancer models:
• DST-64T. A computer-controlled Wheel Balancer that uses Drive-Check™ technology to simulate
driving speed conditions and measure imbalances. Includes an Outer Arm for automatically
determining Wheel Width.
• DST642D. A computer-controlled Wheel Balancer that uses Drive-Check™ technology to
simulate driving speed conditions and measure imbalances.
More information about BendPak Ranger products is available at rangerproducts.com.
This manual is mandatory reading for all users
of the DST-64T or DST642D, including
anyone who installs, operates, maintains, or repairs them.
⚠ DANGER Be very careful when setting up, operating, maintaining, or repairing the equipment;
failure to do so could result in property damage, product damage, injury, or (in very
rare cases) death. Make sure only authorized personnel operate this equipment. All
repairs must be performed by an authorized technician. Do not make modifications
to the unit; this voids the warranty and increases the chances of injury or property
damage. Make sure to read and follow the instructions on the labels on the unit.
Keep this manual on or near the equipment so that anyone who uses or services it can read it.
Technical support for your Balancer is available from your distributor or directly from BendPak Ranger:
using a web browser, visit the BendPak Support website, click on
+ New support ticket, and
then fill in and submit a Support Ticket (make sure to click the Submit button at the bottom).
To Next Page
Loading...
Need help?
General
