DST-64T / DST642D Wheel Balancers 23 P/N 5900192 — Rev. F — March 2021
If the Wheel does not spin or spins counterclockwise instead of clockwise, turn the Balancer off
and contact your dealer, visit www.bendpak.com/support/, or call (805) 933-9970.
Put the Outer Arm against the Outer Edge and wait for the beep.
If there is no beep, refer to Troubleshooting for more information.
Final Checklist Before Operation
Make sure the following has been accomplished
before
using your Balancer:
• Review the Installation Checklist to make sure all steps have been performed.
• Check to see that all Anchor Bolts are in position and tightened.
• Leave the Manual with the owner/operator.
To Next Page
Loading...
