DST-64T / DST642D Wheel Balancers 12 P/N 5900192 — Rev. F — March 2021
Finding a Location
Keep in mind the following when deciding on a location:
• Power source. The Balancer needs to be near an appropriate 220 VAC power source.
• Floor. The Balancer is best used on a flat, concrete floor. If the floor is unstable or not flat, the
Balancer will not work correctly; the readings will be inaccurate.
• Accessibility. You need some space to move the Wheels you are going to balance to and from
the Balancer.
• Danger. When a Wheel is spinning on the Balancer, you need to keep people away from it.
Do
not set up the Balancer in a well-travelled area
.
• No water. The Balancer has electronic components. If the Balancer gets wet while turned on,
those electronic components will most likely short circuit and have to be replaced.
⚠ WARNING Do not use the Balancer if it is sitting in water. You will almost certainly short circuit
the electronic components in the Balancer and you could electrocute yourself.
Clearances
For safety purposes and to allow space to work with Wheels, a certain amount of space around the
Balancer is needed.
You also need enough room
above
the Balancer for the Hood to move up and down freely.
To Next Page
Loading...
