DST-64T / DST642D Wheel Balancers 41 P/N 5900192 — Rev. F — March 2021
In ALU mode, both Adhesive Weight locations are placed at the location determined by the
Inner Arm. Do not place the Weights at 12 o’clock Top Dead Center.
g. Lower the Hood; the Wheel spins briefly.
h. Raise the Hood when the Wheel stops.
The Inner and Outer Windows show the weight that needs to be added to the locations for the
selected ALU Mode.
i. Turn the Wheel slowly to find the best location to put the Inner Weight.
When the Wheel is in the right location, all the Inner Plane LED indicators are lit.
j. Hold the Wheel in place using the Brake pedal.
k. Attach the correction weight(s) (adhesive side up) specified in the Inner Window to the weight
applicator on the end of the Inner Arm.
l. Pull out the Inner Arm and apply the Weight to the Center Plane.
Note: As the Inner Arm is moved, the Center Window will provide a countdown to --0 indicating
the position on the center plane for the correction Weight(s). Push up firmly making sure
the weight(s) adhere to the Wheel.
m. Return the Inner Arm to its rest position.
n. Turn the Wheel slowly to find the best location to place the Center Plane correction weight; all the
Outer Plane LEDs will be lit.
o. Pull out the Inner Arm and apply the Weight(s) to the Center Plane. Press firmly to ensure the
weights adhere to the Wheel.
Note: As the Inner Arm is moved, the Center Window will provide a countdown to --0 indicating
the position on the center plane for the Weight. Push up firmly making sure the weight(s)
adhere to the Wheel.
p. Return the Inner Arm to its rest position.
q. Lower the Hood to spin the Wheel again.
The Wheel is balanced when both the Inner and Outer Windows show 00.
To Next Page
Loading...
Need help?
General
