EasyManua.ls Logo

Ransomes Highway 3 - User Manual

Ransomes Highway 3
94 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
®
RJL 100 January 2013
GB
United
Kingdom
Safety, Operation & Maintenance Manual
Ransomes Highway 3™ Ride on Reel Mower
Highway 3 - 4 Wheel Drive
Series: GF
Product code: LGEA340
Highway 3 - 2 Wheel Drive
Series: GU
Product code: LGEA320
WARNING
WARNING: If incorrectly used this machine can cause severe
injury. Those who use and maintain this machine should be
trained in its proper use, warned of its dangers and should
read the entire manual before attempting to set up, operate,
adjust or service the machine.
24881G-GB (rev.1)

Table of Contents

Other manuals for Ransomes Highway 3

Questions and Answers

  • A
    Alexis MeyerAug 1, 2025
    Why won't my Ransomes Highway 3 engine start?
    • S
      Stephanie GomezAug 1, 2025
      If the engine of your Ransomes Lawn Mower won't start, there are several potential causes. First, ensure the glow plug has timed out by resetting the ignition switch. Check the battery's condition and connections. Make sure the fuel tank isn't empty or contaminated; if necessary, fill it with fresh fuel, change the filter, and bleed the air from the lines. Also, verify that the mow switch is set to 'off' and the transport pedal is in neutral. Finally, inspect the fuse and starter relay, replacing them if defective.
  • W
    william43Aug 6, 2025
    How to fix uneven cutting on Ransomes Lawn Mower?
    • C
      Christopher WhiteAug 6, 2025
      Uneven cutting or poor cut quality with your Ransomes Lawn Mower may be due to several factors. Check if the cutting blades are worn and replace them if necessary. Ensure the engine speed is at full throttle. If the ground speed is too high, adjust the work speed stop. Also, worn cutter motors can cause this issue; in such cases, check the case drain leakage and perform a flow check on the cutting circuit.
  • R
    reedjermaineAug 10, 2025
    What to do if Ransomes Highway 3 engine is overheating?
    • A
      Amanda ThomasAug 11, 2025
      If your Ransomes Lawn Mower engine is overheating, start by checking the coolant level and adding a 50/50 antifreeze solution if needed. Inspect the radiator air intake for any restrictions and clean the wire mesh guard. Also, examine the water pump/alternator belt and fan belt for looseness or breakage, tightening them if necessary.
  • A
    Andrew MillerAug 16, 2025
    Why is my Ransomes Lawn Mower engine hard to start?
    • V
      Victor GutierrezAug 16, 2025
      If the engine of your Ransomes Lawn Mower is hard to start or runs poorly, begin by checking the fuel tank. If it is empty or the fuel is contaminated, fill it with fresh fuel, change the filter, and bleed the air from the lines. Inspect the air cleaner for blockages or dirt, and replace it as needed. For issues with the injectors or fuel pump, consult the engine manual. If there are other engine problems, refer to the engine troubleshooting guide.
  • S
    Savannah GarciaAug 20, 2025
    Why is my Ransomes Highway 3 Lawn Mower battery not holding charge?
    • M
      matthewsdeannaAug 21, 2025
      If your Ransomes Lawn Mower battery isn't holding a charge and the battery light is on, check the battery terminals for looseness or corrosion, cleaning and tightening them as needed. Refill the battery with distilled water if the electrolyte level is low. Inspect the water pump/alternator belt and tighten it if necessary. For a defective alternator, consult the engine manual.
  • A
    alicia79Aug 27, 2025
    What causes Ransomes Highway 3 engine to stop?
    • A
      Alan VasquezAug 27, 2025
      If your Ransomes Lawn Mower engine stops, first check if the fuel tank is empty and refill it with fresh fuel, bleeding the lines. Also, ensure that the parking brake is on and the mow switch is in the off position before leaving the operator's seat.

Summary

Safety Instructions for Mower Operation

Operating Safety Precautions

Key safety instructions, warnings, and advice for operating the mower.

Operating on Slopes Safely

Critical safety advice and procedures for mowing on slopes.

Safety for Maintenance and Cleaning

Safety precautions for performing maintenance and cleaning tasks.

Machine Specifications

Dimensions, Weights, and Tyre Pressure

Detailed specifications for machine dimensions, weights, and tyre pressure.

Machine Specifications Overview

Technical details of the mower's construction, drive, steering, and fluid capacities.

Hydraulic System Specifications

Specifications for the hydraulic system, including flow rates and pressures.

Slope Limitations for Operation

Information on maximum permissible slopes for safe mower operation.

Cutting Unit Specifications

Technical details for different cutting unit models, including construction.

Recommended Lubricants Guide

Guidance on lubricants for engine, hydraulic system, and grease based on temperature.

Engine Specifications

Detailed specifications of the engine, including type, displacement, and power.

Mower Controls and Instrument Panel

Operator Workstation Layout

Overview of the operator's station layout and key control locations.

Instrument Panel Controls and Indicators

Identification of controls and indicators on the instrument panel.

Starter Key Switch Operation

Operation and function of the starter key switch for ignition.

Cutting Unit (PTO) Switch Operation

Operation of the switch to engage and disengage cutting units (PTO).

Visual Display System Overview

Overview of the machine's visual display system and its screens.

Warning and Service Screen Information

Display of warnings, service indicators, and fault reporting.

Main Run Screen Details

Details of the main operating screen, including status indicators and symbols.

Water Temperature Warning Screen

Display and warnings related to engine coolant temperature levels.

Slope Warning Screens

Display of warnings and actions related to operating on slopes.

Service Menu Access and Functions

Accessing service logs, time-to-service, and diagnostic information.

Traction Pedal Operation Guide

Operation of the forward/reverse traction pedal and speed selector.

Operation Procedures and Guidelines

Operator Presence and Safety Interlock System Test

Testing the safety interlock system for proper functioning.

General Operating Procedures

General guidelines and precautions for operating the mower safely.

Engine Starting and Driving Procedures

Procedure for starting a cold engine and basic driving techniques.

Mowing Operations and Engine Shutdown

Steps for engaging cutting units, mowing, and safely shutting down the engine.

Mowing on Slopes Safely

Precautions and safe practices for mowing on inclines and slopes.

Maintenance and Lubrication Schedule

Maintenance and Lubrication Chart

Schedule of maintenance tasks and lubrication points with corresponding sections.

Engine Lubrication Procedures

Procedures for checking and changing engine oil and oil filter.

Hydraulic System Oil and Filter Service

Procedures for checking and changing hydraulic oil and filter.

Fuel System Procedures

Bleeding air, changing fuel filter, and draining the fuel tank.

Adjustments for Mower Performance

Cutting Cylinder to Bottom Blade Adjustment

Adjusting the cutting cylinder to achieve correct contact with the bottom blade.

Troubleshooting Common Issues

General Troubleshooting Guide

Common symptoms, causes, and actions for troubleshooting mower issues.

Ransomes Highway 3 Specifications

General IconGeneral
BrandRansomes
ModelHighway 3
CategoryLawn Mower
LanguageEnglish

Related product manuals