en-43
CONTROLS 5
5.6.12 EMISSION FAULT – EGR NOX CONTROL _______________________________
When this screen is shown, the engine controller (ECU) is reporting a fault
with EGR system or sensor.
The output from the engine will be reduced.
Stop the engine as soon as possible and contact your local Ransomes
Jacobsen Dealer.
5.6.13 EMISSION FAULT – MAF SENSOR ___________________________________
When this screen is shown, the engine controller (ECU) is reporting a fault
with the MAF (Mass Air Flow) sensor. The output from the engine will be
reduced. Stop the engine as soon as possible and contact your local Ran-
somes Jacobsen Dealer.
5.6.14 EMISSION FAULT – DPF SENSOR ____________________________________
When this screen is shown, the engine controller (ECU) is reporting a fault
with the DPF (Diesel Particulate Filter). Stop the engine as soon as possi-
ble and contact your local Ransomes Jacobsen Dealer.
5.6.15 CLEAN DPF ASH __________________________________________________
When this screen is shown, the engine controller (ECU) is reporting that
the level of ash in the DPF (Diesel Particulate Filter) is in excess of 95%
and therefore the DPF needs to be serviced. Contact your local Ransomes
Jacobsen Dealer for information on the procedure for servicing the DPF.
To Next Page
Loading...
