Ransomes MP653 - Page 89

en-85
MAINTENANCE AND LUBRICATION 8
8.5
8.2
8.2
8.8
8.3
8.2
B
A
Interval Item Section
Every 2 Years
 Replace Oil Separator Related Rubber Piping.
 Replace DPF Related Rubber Piping.
 Replace Intake Air Line and Suction Air Pressure
takeout Rubber Piping.
 Replace Boost Sensor Pressure Rubber Piping.
 Replace EGR Cooler Rubber Piping.
 Replace Water Rubber Piping.
 Replace Lubricant Rubber Piping.
 Change Radiator Coolant.
 Replace Radiator Hoses and Clamp Bands.
 Replace Fuel Pipes and Clamp Bands.
 Replace Intake Air Line.
 Replace Auxiliary Belt (or Every 500 Hours)
*3
*3
*3
*3
*3
*3
*3
-
*3
*3
*3
*3
The jobs indicated by  must be done after the first 50 hours of operation.
*3 Consult your local Kubota Dealer for this Service.
The items listed above (@ marked) are registered as emission related critical parts by
Kubota in the U.S.EPA non road emission regulation. As the engine owner you are
responsible for the performance of the required maintenance on the engine according to the
above instruction.
Please see Warranty Statement for detail.
The items listed above other than @ marked items are not necessary to keep the
emission-related warranty valid.
Failure to perform the maintenance will cause problems that will significantly degrade
IMPORTANT
Refer to Engine Manufacturers Manual for the Complete Engine Maintenance Procedures