understanding the monıtor led dısplays
5
Front LED Display
Monitor is switched on, but not ready to measure.
red light ‘‘ not ready ’’
Monitor is ready for hitting. When appearing after
blue light just after a hit, data is ready to be
viewed on app, and ready for next hit.
Monitor is processing data after a valid hit. Wait
for the green light to appear which should take
only a few seconds.
green light ‘‘ pıtch ’’
blue light
‘‘ processıng ’’
The front LED display provides information on the
monitor status, and will give the “Green light” to hit
when the device is ready to measure.
Rear LED Display
Not connected to RCE, waiting for USB sync.
red light
Successfully connected to RCE through USB.
green light
Switched off, and charging.
amber light
If USB is plugged into a charging device or PC,
it means the battery is fully charged.
off
Warning for low battery, please recharge monitor.
red flashıng light
The rear LED display provides information on
connectivity and battery. This display will be
especially important when pairing the app with the
monitor.
To Next Page
Loading...
Need help?
General