EasyManua.ls Logo

Raritan Crown Head User Manual

Raritan Crown Head
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
1
THE FOLLOWING ARE CAUTIONARY STATEMENTS THAT MUST BE READ AND
FOLLOWED DURING BOTH INSTALLATION AND OPERATION.
WARNING: Raritan Engineering Company, Inc. recommends that a qualied person or electrician install this
product. Equipment damage, injury to personnel or death could result from improper instal-
lation. Raritan Engineering Company, Inc. accepts no responsibility or liability for damage to
equipment, injury or death to personnel that may result from improper installation operation of
this product.
WARNING: HAZARD OF SHOCK OR FIRE
Always use recommended fuse, circuit breaker and wire size.
Motors and relays used with this product are “Ignition Protected”. They are not however, ex-
plosion-proofasdenedin46CFR110.15-65(e),SubchapterJ-ElectricalEngineering.
DO NOTrunthissystemdry(withoutwater).
DO NOTruncontinuouslyformorethan30seconds.
WARNING: HAZARD OF FLOODING -Alwaysshutoseacock(s)beforeleavingtheboatunattended.
Wheneverpossiblehoseconnectionsshouldbesecuredusingtwo(2)all-stainlesssteelhose
clamps.Integrityofclamps,hosesandttingsshouldbecheckedperiodically.
INTRODUCTION
The Crown Head is a powerful centrifugal
macerating toilet that thoroughly breaks down
waste in preparation for treatment or holding and
requires little maintenance. It can be ordered with
a90degreeorastraightdischargetting,awhite
marine-size bowl or household-style bowl available
in either white or almond.
OPERATION
CAUTION: The Crown Head motor is designed
to be used as a toilet and is not rated for
continuous duty.
TheCrownHeaddoesn’trequirespecialtoiletpaper,
however,hardobjectsorstringysubstances(paper
towels,femininehygieneproducts,ltercigarettes,
etc.)must not be thrown into the toilet as they will
cause damage.
A. Momentary Operation Using Push-button
Switch (#164000BR) - not included: Depress
button and hold. Water should appear in the
bowl within one tofourseconds. Flush as
necessary.
MAINTENANCE
1. Rell the reservoir when empty; occasionally
check that it has not run dry.
C.P.,CleansPotties,(1PCP22)helpsminimize
the need for cleaning.
Use only Raritan Cleans Potties as an additive in
the Concentrate tank. Other products may cause
damage to the internal parts of the toilet.
2. Using C.P. a bio-enzymatic toilet bowl cleaner
(available from Raritan Engineering) will keep
the bowl clean and fresh smelling.
Do not use any chemical that contains ammonia,
ethyl acetate, phosphoric acid or concentrated
chlorine bleach as a cleaner. These may cause
damage to the toilet.
3. Make a periodic visual check for leaks at the base of
the toilet and at hose connections.
4. Checksemiannuallytoensureallwireterminalsand
junctions are corrosion-free.
5. Whenboatisnotinuse,ushingthesystemwithfresh
water will help minimize odors and reduce mineral
buildup.
1/2” (1.3cm)
(approx.)
2”
(5.1cm)
13 7/8” (34.2cm)
10 7/8” (27.6cm)
11 7/8” (30.2cm)
14 3/8”(36.5)Household-style
13”(33cm)
Marine-size
17 3/8”
(44.1cm)
Household-style
17”
(43.2cm)
Marine-size
FIG 1
Side
Front
6 1/4”
(15.9cm)
8 9/16”
(21.9cm)
20”(50.8cm) Household-style
17”(43.2cm)
Marine-size
L910116jlc
1
CROWN HEAD - Overall Dimensions
crown head
CENTRIFUGAL DISCHARGE SERIES AUTOMATIC MARINE TOILET
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS

Questions and Answers:

Raritan Crown Head Specifications

General IconGeneral
BrandRaritan
ModelCrown Head
CategoryToilets
LanguageEnglish

Summary

Operation

Momentary Operation Using Push-button Switch

Describes momentary operation using a push-button switch for flushing.

Maintenance

Winterizing

Seacock and Hose Preparation

Close seacocks, disconnect and drain hoses for winterizing.

Antifreeze Circulation

Steps for circulating antifreeze through the toilet system.

Recommissioning

Antifreeze Removal

Flush out antifreeze with clean water and dispose properly.

Hose and Seacock Reconnection

Reconnect hoses and open seacocks after winterizing.

Installation

Mounting the Crown Head

Instructions for mounting the Crown Head on a solid deck.

Intake Line Connection

Connecting the 3/4" intake line to the seacock.

Discharge Line Connection

Connecting the 1 1/2" discharge line to its destination.

Plumbing

Vented Loops for Below-Waterline Installations

Vented loops are required for below-waterline installations to prevent siphoning.

Wiring

System Start-Up

Troubleshooting

Related product manuals