Raritan Marine Elegance User Manual

1
Installation and Maintenance Instructions
Description:
Our Marine Elegance toilet is available in 12V or 24V DC. Bowls
are available in four models: standard with angled back, standard
with straight back, tall with angled back and tall with straight
back. Fresh water model utilizes onboard freshwater, the Sea
water model utilizes a remote pump installed between raw water
source and bowl. Sea/Fresh model can switch between fresh and
raw water source.
Flush control options available:
1. Smart Toilet Control: provides timed operation and inde-
pendant control of water and discharge.
2. Multifunction Flush Panel: provides momentary operation
and independant momentary control of water and discharge.
3. Momentary Flush Switch: providing only the ability to
ush with no independant control of water or discharge.
4. Touchless Flush Sense Control: designed to activate a ush
cycle without touching the control. Simply wave your hand
within 2” of the sensor.
5. Wireless Remote Bluetooth Control: program your STC
wirelessly up to 50 ft away from the toilet. Eliminates the need
to route wires through bulkheads and cabinetry.
Marine
Elegance
THE FOLLOWING ARE CAUTIONARY STATEMENTS THAT MUST BE READ AND
FOLLOWED DURING BOTH INSTALLATION AND OPERATION.
WARNING: Raritan Engineering Company, Inc. recommends that a qualied person or electrician install this product.
Equipment damage, injury to personnel or death could result from improper installation. Raritan Engineering
Company, Inc. accepts no responsibility or liability for damage to equipment, injury or death to personnel that
may result from improper installation or operation of this product.
WARNING: HAZARD OF SHOCK OR FIRE
Always use recommended fuse, circuit breaker and wire size.
Motors used with this product are “Ignition Protected”. They are not however, explosion-proof as dened in 46CFR
110.15-65(e), Subchapter J-Electrical Engineering.
DO NOT run continuously for more than 30 seconds.
Pressurized
Freshwater Model
Sea Water Model
(Remote Pump)
Manufactured after August 2016
Model and Serial Number:
1-800-352-5630
www.raritaneng. com
L490 0720jlc
Toilet

Raritan Marine Elegance Specifications

General

Type	Electric
Bowl Material	Vitreous china
Bowl Shape	Elongated
Voltage	12V DC, 24V DC
Water Source	Pressurized water system or raw water
Discharge Outlet	1" (25mm) or 1 1/2" (38mm) hose
Mounting	Floor
Certification	ABYC

Summary

General Safety Warnings

HAZARD OF SHOCK OR FIRE

Always use recommended fuse, circuit breaker, and wire size. Motors are 'Ignition Protected' but not explosion-proof.

Product Description

Flush Control Options

Details various flush control methods including Smart Toilet Control, Multifunction Flush Panel, Momentary Flush Switch, Touchless Sense Control, and Wireless Remote Bluetooth Control.

Important Safety Instructions

HAZARD OF FLOODING

Always shut off seacock(s) before leaving unattended. Double clamp all below waterline hose fittings.

Child Safety Warning

Young children should not be left unsupervised. Serious injury or death could occur from drowning or closing seat/lid.

Recommended Visual Inspection

Cleaning Instructions

Winterizing Procedures

Pressurized Freshwater Models

Steps and parts required for winterizing the Pressurized Freshwater model, including closing seacock, draining, and adding antifreeze.

Integral and Remote Intake Pump Models

Steps and parts for winterizing Integral and Remote Intake Pump models, including closing seacocks, draining, and adding antifreeze.

Recommissioning and System Start-Up

Plumbing Specifications

Hose Sizes

Details recommended inlet and discharge hose sizes for freshwater and sea water models.

Wire and Fuse/Circuit Breaker Sizing

Provides recommended wire gauge, fuse/breaker size based on voltage and distance for sea water and freshwater models.

Mounting Instructions

Mounting Surface Requirements

Toilet mounting surface must be flat and solid. Seat must open more than 90 degrees.

Hole Drilling Dimensions

Provides dimensions for drilling holes for discharge hose, inlet hose, and wires according to FIG 2.

Plumbing Details

Vented Loop Requirements

Toilets below waterline must have vented loops installed in discharge and intake plumbing to prevent flooding.

Residual Water in Bowl

Explanation of the integral vent's function and when to remove the vent cap for proper bowl water retention.

Discharge and Inlet Lines

Discharge Line Connections

Instructions for connecting discharge hose to the toilet and routing it to a treatment system or holding tank.

Remote Pump Mounting

Guidance on locating, installing, and securing the remote pump away from the berth for noise reduction.

Wiring and Toilet Mounting

Wiring Safety and Sizing

Emphasizes proper wire size, connectors, fuse/breaker selection, and secure wiring practices for safety.

Mounting the Toilet

Steps for installing mounting bushings, bolts, and caps, with a torque specification of 30 inch-lbs.

Troubleshooting Guide

Poor Pumpout or Water Flow

Addresses causes like clogged lines, low voltage, or intake restrictions and provides solutions.

Foul Odors and Bowl Filling

Solutions for foul odors from the bowl or sewage line and causes for the bowl filling while underway.

Exploded Parts List

Flush Control Options Parts

Lists parts for Smart Toilet Control, Multifunction Flush Panel, and Momentary Flush Switch options.

Remote Intake Pump Parts

Details components for the remote intake pump unit, including motor, fittings, and clips.

Limited Warranty Information

Warranty Service and Coverage

Explains how to obtain service, what is covered, and exclusions like modifications or misuse.

Liability Limitations

Disclaims liability for special, incidental, or consequential damages and limits implied warranties.