Rascal Frontier - Engineers Checklist for Rascal Frontier and Pioneer

24 Rascal Frontier & Pioneer Scooters Owner’s Manual & Service Record
Engineer’s Checklist for Rascal Frontier and Pioneer
Important Note for the Engineer
Enquire if the customer is satisfied with the product. Please report all points good or bad directly to:
Electric Mobility 01460 258100 If you have any comments please include them.
Obtain all comments from the customer on the condition and serviceability of the scooter and then complete
an Initial diagnostic road test. Record all defects to be corrected. Now check, test and complete the following:
• Wheel bearings wear and lubricate
• Wheel alignment and tracking
• Speed dial works correctly
• Speed Hi Lo selection (if fitted) operates correctly
• Wear or damage to tyres or wheels
• Bodywork fixtures for damage, or cracking
• Throttle play and adjustment
• Battery enclosure contacts & signs of corrosion
• Check all cables for damage, abrasion, corrosion
and that screening is intact. Replace as necessary
• Steering bearing, adjust as required
• Tiller adjustment - functioning, wear and damage
• Tiller lock – functioning, wear and damage
• Seat mounting for wear or damage
• Revolving seat mechanism locates correctly and
spring lever engages. Lubricate as necessary.
• Seat position adjustment, Does the seat
move frontwards and backwards smoothly?
Does the seat lock?
• Handlebar alignment
• Motor brush wear
• Motor speed check
• Freewheel operation
• Electromagnetic brake operation - does the
scooter slow when the hand control is released?
Does the brake engage when the scooter is
pushed when in freewheel ?
• Emergency Brake. – does the emergency brake prevent
the vehicle from moving? Does it need adjustment?
• Frame for damage or cracks
• Front and rear chassis attachment points for
corrosion, wear or damage
• General check for corrosion, repair/protect as necessary
• All operational controls work correctly
• Battery condition and charger operation
• Tighten all nuts & bolts
• Check all vehicle lights operate correctly and the
horn functions
• Correct all defects found and determine
if the vehicle is roadworthy.
• Final road test
• Clean vehicle
• Customer road test