EasyManua.ls Logo

Rascal Smilie - Tiller Adjustment & Lock; Transferring in & out of the Scooter

Rascal Smilie
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Tiller Adjustment & Lock
The telescopic tiller can be height adjusted for a
comfortable riding position and lowered for
transport and storage.
Take care when adjusting the tiller not to pinch
your
fingers on the slide of the tiller. Once in the
desired position, the tiller can be locked in place.
Tiller Height Adjustment:
Rotate the tiller knob anti-clockwise
sufficiently to allow the tiller tube to move
(Fig.14).
Raise/Lower the tiller so that it
is in its required
position.
Rotate the tiller knob clockwise and ensure
that it is tight.
Do not extend the telescopic tiller beyond the
limit-line marked as maximumon the tiller tube
(Fig. 15).
Transferring In & Out of
the Scooter
If you feel at all uncertain about getting in or out of
the scooter seek assistance.
Transferring into the Scooter from the Front
Before getting in:
Make sure that the scooter is on a level
surface, and that it is not in Freewheel
mode, and the freewheel lever is in ‘Drive’
position.
Make sure the brakes are engaged - try to
push
the scooter a little to verify that the brakes are
working.
Ensure that the ignition key is turned off
(Fig.16 Pg.12).
(The LED / lamp on the
dashboard will not illuminated or flashing) (Fig.16)
Ensure that the tiller adjustment is fully
tightened, and that any accessories are properly
fitted and secured. (Fig. 14)
The seat back should be in the upright
11
You are now ready to get in:
Approach the seat from the side and step over
the centre part of the scooter with one foot. You
should now be straddling the scooter facing for-
wards and with the seat behind you
. With your
back
to the seat, you can steady yourself using the
arm- rests and then lower yourself gently into the
seat.
Lift each of your feet onto the footrest platform.
Getting out of the Scooter:
Before getting out of the scooter, be sure that it
is
on a level surface, the scooter is stationary, and
the power key is switched to the off position. If you
feel uncertain about getting out, seek assistance.
Move the handlebars so that the front wheels are
facing directly forwards.
Lift your feet off the footrest platform and stand-
up using the armrests to provide you with
additional stability if required. (D
o not put your full
weight on the armrests).
Warning! Before driving, always check that
the tiller is secured. Safe steering
will be
impossible if you do not !
14
15

Related product manuals