Raspberry Pi 4 b Installation Guid

5. End Product Labelling
A label is to be fitted to the exterior of all products containing the Raspberry Pi 3 Model B+ module.
The label must contain the words “Contains FCC ID: 2ABCB-RPI4B” (for FCC) and “Contains IC: 20953-
RPI4B” (for ISED).
FCC
Raspberry Pi 4 Model B 1GB, 2GB, 4GB + 8GB variants FCC ID: 2ABCB-RPI4B
This device complies with Part 15 of FCC Rules, Operation is Subject to following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received including interference that cause undesired
operation.

Raspberry Pi 4 b Specifications

General

Processor	Broadcom BCM2711, Quad core Cortex-A72 (ARM v8) 64-bit SoC @ 1.5GHz
RAM	2GB, 4GB, or 8GB LPDDR4-3200 SDRAM (depending on model)
Ethernet	Gigabit Ethernet
Video Output	2 × micro-HDMI ports (up to 4Kp60 supported)
Storage	MicroSD card slot for operating system and data storage
GPIO	40-pin GPIO header
Power Supply	5V DC via USB-C connector (minimum 3A*)
Wireless	2.4 GHz and 5.0 GHz IEEE 802.11ac wireless, Bluetooth 5.0, BLE
USB Ports	2 × USB 3.0 ports, 2 × USB 2.0 ports
Audio Output	3.5mm audio jack
Operating Temperature	0 – 50 °C
GPU	VideoCore VI graphics
Power Options	USB-C or GPIO header